K&W 401224 FiberLock Head Gasket & Block Repair - 32 Fl Oz

I have a suspicion that the bad reviews of this product are coming from people who are using it incorrectly. I had a blown head gasket (confirmed by repair shop when they replaced my timing belt, water pump, and thermostat) on a 1995 1.5L Honda Civic engine. The only reason I picked up a bottle of this sealant was because the mechanic recommended it after I told him that I couldn't afford a $500 dollar repair bill for replacing the head gasket. The mechanic told me that he'd used this stuff before and that it was pretty much the only head gasket sealant on the market that he'd ever seen work and told me that he would never recommend any other but this stuff actually works. So I ordered a bottle and gave it a try. The first thing I noticed was that the instructions clearly state that you should read the entire label before starting and that you should know exactly how much fluid your radiator and engine block hold and to use a specific amount based on the volume. It also clearly states that if your water pump or thermostat are not properly working that it will not work properly and could cause uneven distribution of the product. It states clearly on the label to use the proper amount and to add it very slowly into the properly diluted radiator fluid and not to add the product until the fluid level is high enough not to touch the fins on the inside of the radiator. After doing just that, letting the engine run and the coolant cycle and then topping it off, and then letting it idle for over 15 minutes with the heat on, I could already tell that the engine was running as smoothly as it did before the blown gasket. After several days of driving, it no longer overheats, no longer produces white smoke from the coolant leaking through the gasket into the engine, no long is leaking oil into the coolant and is no longer running rough. The stuff is very clumpy and can look worrying but when the proper amount (for me 1/3 a bottle) is added to properly mixed 50/50 fluid, it cycles through and smooths out. I plan on letting it stay in the engine until I get ready to flush the radiator out and get the rest off the product out but the bottle clearly states that you can leave it in without flushing and that it will not cause clogging or sludge. So far it has work perfectly and seems to have sealed the gasket completely but even if it does begin to leak slightly, it says that you can add more which I plan to do if it does, though so far it after 4 days of daily commuting for 36 miles, it has had no problems and works perfectly. I'd recommend it to anyone who can properly follow instructions but I would imagine that if you added it to the wrong coolant type or mixture or if you added way more than was intended that it would cause major problems with clogging up your system. Having a new water pump probably also helps, as I would imagine that if your water pump wasn't properly cycling the stuff that it would clog up in the system and prevent the sealant from reaching the leaking points and possibly clog up the radiator or heater coils. Use it as intended and it should turn out just fine.

used this to fix a hairline crack somewhere in the block or timing cover. so i have a 2010 jeep grand cherokee with a 5.7 hemi motor, bought it real cheap due to haveing a head gasket issue due to an overheat , im a tech for 40 years and know these hemi's well ,i did all the work myself , replaced both head gasket heads were sent out and resurfaced and i did a valve job , the motor fired right up and ran perfect when finished , however i noticed my coolant level was dropping slowley with know external leaks , after investigating i found coolant in my catch can so know i knew that it was getting into the crankcase, after i drained out about 8 0z of oil from the sump i saw a little bit of coolant in there but not to bad and not a lot . the coolant seemed to be entering the crankcase but more as a vapor if anything because most was in my catch can. there was a hairline crack somewhere . i decided to try this but was very skeptical . and low and behold it worked ! i couldn't believe it , no more coolant in my catch can or in the bottom of oil sump , i was amazed it actually worked , its been a year now with about 7k miles and still holding up! no coolant loss ,no heater core or radiator issues, i did put a new thermostat in it after about 100 miles running on it and found some hardened material around it but i wasn't worried about it after i installed a new one . i recommend this if you have a small leak due to a crack .

I bought this just a few days ago because my 2005 Hyundai Elantra was over heating and cooling within a couple miles of driving. The temp gauge would spike to the top and then slowly go back down to the middle mark. The Heater would blow cold air, then a couple mins of hot air then go cold again. I had to replace fluids every time I needed to drive anywhere and just before I used this product I found moisture droplets and milky residue on the oil stick. The thing that sucked is that all this happened right after I had the valve cover gasket replaced, the radiator replaced because we found a large hole near the cap area, had an oil change, replaced all the spark plugs and wires (actually, I had to replace them a 2nd time because the were being destroyed by the over heating issue) and repaired the exhaust and catalytic converter (even after the CC repair I was burning though gas and having some misfiring issues. which is why I had to change the spark plugs a 2nd time just before I tried K&W). So needless to say I did a lot of work on this car (A COUPLE WEEKS) before I realized there was an issue with the head/cooling system. This is my only car and I rely on it to get to my college classes and take care of my kid. I'm a single mom, thankfully with a bit of mechanical knowledge. So, I read all the reviews....good and bad. And I noticed a trend. All the good reviews said they followed the directions explicitly. So that's what I did. First, I hadn't driven my car in 2 days. I borrowed my mom's car for those 2 days just so I knew it was a 100% cold engine. Then, although I was reluctant about adding it directly to the brand new radiator I just bought (a month ago) I had to, because I couldn't get the top hose off. So, I added 1/3 of the bottle to the radiator and then added some distilled water to it as well. Because, I had read from some of the other reviews that coolant and this product do not mix well. If i need to add more coolant later I will. For now I just used enough distilled water to top off the fluids. I also added distilled water to my reserve tank. ALSO NOTE, the instructions say to start the car and leave it running on idle while SLOWLY ADDING the CORRECT amount of K&W. After SLOWLY ADDING it to my idling engine, I let it continue to run on idle, I turned the heater on FULL BLAST for 30 mins and I sat in the car watching the temp gauge, it did creep up to quarter mark but didn't get to the half mark, which was a great sign! I'll try to add to this review over time. As I just used it today, so only time will tell if it truly works. But I am keeping a positive mindset. I need this to last at least until taxes, then I can think about a "newer" car. I hope this review helps someone else. *Update: Almost 2 months later and my car is still holding up! (Dec. 19, 2019)

Doesn’t Work I bought this because I had a hose blow out and caused head gasket issues. Bought this product taking a gamble that it would seal. Unfortunately doesn’t work. Don’t waste money on this product. Very unhappy with the product. Wish I would have saved time and money on this.

I had a cracked head/leaky head gasket, could only drive about one mile before car would overheat and spue out coolant. Installed product according to directions and ran engine again according to directions. The leak was stopped, but the radiator was completely clogged by product, but, replacing radiator was a lot cheaper than replacing head or head gasket. I have driving car several months since treatment, and it is working fine. I give it a good product star. Now have driven car many thousands of miles and is working fine. Again, great product.